The LCD Display will show the camera’s current settings in Setup Mode. The AIM position can also be used to verify the area the camera will monitor. When the power switch is set to the AIM middle position, the camera is in Setup Mode. A 3-way power/mode switch is used to select the main operating modes: OFF, AIM, and ON (Fig. Release the two latches on the right side of the camera and swing the front cover over to the left to access the controls. The Tasco Trail Camera is designed for outdoor use and is water resistant. The Tasco Trail Camera is equipped with built-in infrared (IR) LEDs that function as a flash, so that it delivers clear photos or videos (in black & white) even in the dark, and it can take color photos or videos under sufficient daylight. Once motion in the monitored area is detected, the digital camera unit will be triggered at once (typically less than 1 second) and then automatically take photos or videos (your choice). This means it can deliver up to six months stand-by operation time when the device is powered by eight AA alkaline batteries, and up to twelve months utilizing eight lithium AA batteries (30 images per day, 15 w/flash). The Tasco Trail Camera consumes very little power (< 0.5mA) in a stand-by (surveillance) state. Or 8MP resolution, depending on model), or video clips (720p, 10 seconds length). It can be triggered by any movement of live animals in a location, detected by a highly sensitive Passive Infra-Red (PIR) motion sensor, and then take high quality photos (6MP Your new Tasco® Trail Camera is a digital scouting camera. Tasco recommends using SanDisk® SD and SDHC Cards (up to 32GB capacity) in this Tasco trail camera.
0 Comments
Leave a Reply. |